Advanced Setup - Wireless - Sanyo POA-WL11 Operación Manual

4.3.4. Advanced setup – Wireless
On the wireless setup screen of the advanced setup, wireless related items of Wireless Imager can be set.
Parameter
Wireless Mode
Channel
SSID/ESSID
WEP Security
WEP key 1 to key 4
Set the wireless communication mode in the environment you wish to use.
Select either "Infrastructure" or "AdHoc".
"AdHoc" provides "Pseudo AdHoc" and "802.11 AdHoc". Using the DIP
switch on Wireless Imager unit, set a desired AdHoc mode. (For details,
see [1.4. Part names and functions of main unit] in Chapter 1.)
To check which mode is currently set, press the TEST switch on Wireless
Imager. (For details, see [1.4. Part names and functions of main unit] in
Chapter 1.)
Set the channel when the system is used in the "Pseudo AdHoc" mode.
Select from available channels in each region; North America (USA and
Canada): 1 ~11; Europe: 1~13; France: 10~13.
Set SSID/ESSID when the system is used in the "Infrastructure" or
"802.11 AdHoc" mode.
[NOTE] If a SSID/ESSID, other than "ANY", is to be used in Infrastructure
mode, the same SSID must be set to Wireless Imager, access
point, and the wireless-enabled client PC.
In 802.11 Adhoc mode, the same SSID must be set to Wireless
Imager and the wireless-enabled client PC.
SSID/ESSID is case-sensitive. Even though all characters
projected by pressing the TEST switch on Wireless Imager are
uppercase, it is necessary to discriminate between upper and
lower case characters.
Set whether or not WEP (Encryption) is used.
When using WEP, select any of [Enable (40bit/Shared Key)], [Enable
(40bit/Open System)], [Enable (128bit/Shared Key)], and [Enable
(128bit/Open System)] corresponding to this WEP.
[NOTE] When using WEP (Encryption), the image transfer speed may
become slow.
Set WEP key in the hexadecimal notation (0 to F). 5 bytes are set for 40-
bit WEP and 13 bytes are set for 128-bit WEP.
— 37 —
Chapter 4. Setting up Wireless Imager
Description