Sanyo POA-WL11 Operación Manual página 54

Chapter 5. Operating the WI Client
9. PJ Controller
When selecting [PJ Controller...], you can launch PJ Controller to operate and configure the projector
from your PC. (Refer to 5.4. PJ Controller, for more details)
[NOTE] You cannot launch [PJ Controller...] while the PC is connected to Wireless Imager in either
Real-Time mode or in One-Shot mode. Make sure that WI Client is in [Disconnect] state.
If there are multiple Wireless Imager units in the area, make sure in [Connect to Wireless
Imager Host] screen that you are connecting to the correct target. You are not allowed to
connect PJ controller to multiple Wireless Imager Units.
10. Quit
When selecting [Quit] during real-time capture, the communication is disconnected and WI Client is
then exited. (Refer to [5.5. Exiting WI Client] for more details)
— 54 —