Establishing A Direct Wlan Connection (Access Point Mode) - Oase InScenio EGC Controller Home Instrucciones De Uso

How to proceed:
On the router:
Press the WPS button on the router to activate WPS.
Follow the information given in the router operating instructions.
WPS is only active for a limited time. Activate WPS on the InScenio EGC Controller during this time.
 H
On the EGC Controller:
1. Press the button briefly (max. 2 seconds) to activate the WPS.
The LED is lit green and flashes rapidly.
The WPS remains active for 2 minutes.
The connection is established when the green LED flashes slowly (2 seconds on, 1 second off).
On the smartphone/tablet:
2. Establish a connection to the WLAN router.
3. Start the "OASE Easy Controlʺ app.
InScenio EGC Controller can now be controlled using the "OASE Easy Control" app.
6.2.2

Establishing a direct WLAN connection (access point mode)

If there is no router available or the existing router does not support WPS, it is necessary to establish a direct
connection between the InScenio EGC Controller and a smartphone/tablet. This is also recommended if the
distance from the router exceeds 80 m or the WLAN range for connection to the router is exceeded.
The range of the WLAN connection between the InScenio EGC Controller and your smartphone/tablet can span
a distance of up to 80 m provided there is unobstructed signal transmission and there is no source of inter-
ference.
Compatibility with the following WLAN standards: 802.11n+g+b
Exclusively in the frequency range 2.4 GHz.
The network name (SSID)
The sequence of letters "xxxxxx" in the network name (SSID)
the MAC address of the EGC controller.
The standard password
The InScenio EGC Controller is factory-set to the standard password
The connection is encrypted and protected by a password.

is indicated on the label on the InScenio EGC Controller.

is also indicated on the label on the InScenio EGC Controller.

is device-specific and represents part of

"oase1234".
- EN -
41