Festool PLANEX easy LHS-E 225 EQ Manual De Instrucciones página 18

Problem
Sanding marks on the
surface
LHS-E 225 switches off
while working and after
three beeps
LHS-E 225 not working
LHS-E 225 not working
and beeps three times
when an attempt is made
to switch it on
If problems other than those listed occur, please contact your Festool service workshop or your local spe-
cialist dealer.
Information on data protection
The power tool contains a chip which automatically
stores machine and operating data (RFID). This
data saved cannot be traced back directly to an in-
dividual.
The data can be read using special (contactless) de-
vices and shall only be used by Festool for fault di-
18
Possible causes
Sanding pad is placed down on
the surface at an angle
The abrasive grit is too coarse for
very soft spackling paste.
Cool air filter on the LHS-E 225 is
blocked.
Excessive pressure -> power tool
activates overheating protection.
plug it is not connected correctly. Check that the plug it is securely con-
Interruption to power supply
Overheating protection active
Remedy
Place the sanding pad down so that it is
level.
Choose a finer abrasive grit (abrasive
Brilliant 2 available up to grit P 320).
Clean the cool air filter on the LHS-E 225,
see Section. Cleaning the cool air filter [8]
.
Let the power tool cool down for approx.
15 minutes and then apply less pressure.
nected.
Switch the power tool off and on again.
Let the power tool cool down for approx.
15 minutes before switching it back on
again.
agnosis, repair and warranty processing and for
quality improvement or enhancement of the power
tool. The data shall not be used in any other way
without the express consent of the customer.