Lanaform Power New Tech Manual De Instrucciones página 5

ACCESSORIES
• 2 M8 x 20 bolts
• 2 M5 x 12 bolts
• 4 M6 x 30 bolts
• 1 M8 screwdriver
• 2 Locking knobs
• 4 M6 washers
• 2 M5 washers
• 2 M8 washers
ASSEMBLY INSTRUCTIONS
1) Insert the upper column into the lower column..
2) Lower the decorative ring to cover the connection between the two columns. Carefully align the holes in the ring with
the holes in the columns and secure with the two locking knobs.
3) Once the two columns have been assembled, place the support bar in position.
4) Use two M8 x 20 bolts and two M8 washers to attach the support bar to the column.
5) Place the control panel on top of the column and slide the connecting power cable inside the column.
6) Attach the control panel to the support bar using two M5 x 12 bolts and two M5 washers.
7) Connect the electrical power cable as shown in the diagram.
8) Insert the end of the lower column into the base of the unit such that the bolt holes are correctly aligned. Insert the
two M6 x 30 bolts with M6 washers into the holes in positions b and c and tighten them down. Insert the two M6 x
30 bolts with M6 washers into positions a and d and tighten them down.
Your unit is ready for use.
Power New Tech
EN
5