Every Day; Periodic Maintenance; Tightening Torques - Chicago Pneumatic CP 0112 Instrucciones De Seguridad Y De Funcionamiento

CP 0112, CP 0112 S, CP 0112 EX

Every day

Before undertaking any maintenance or changing
the insertion tool on pneumatic machines, always
switch off the air supply and bleed the machine by
depressing the start and stop device then disconnect
the air hose from the machine.
Clean and inspect the machine and its functions
♦
each day before the work commences.
Check the tool retainer for wear and function.
♦
Conduct a general inspection for leaks and
♦
damage.
Check that the air inlet nipple is tightened and
♦
that the claw coupling is free from damage.
Check that the backhead bolts are tightened
♦
according to section "Tightening torques".
For the machine to maintain the specified
♦
vibration values, always check the following:
Too large a clearance between the insertion tool s
shank and the chisel bushing will generate
increased vibrations. To avoid getting exposed to
excessive vibrations, check the chisel bushing for
wear every day.
If the machine has a vibration-absorbing
♦
handle/handles, check that it moves freely (up
and down) and does not jam.
Change damaged parts immediately.
♦
Replace worn components in good time.
♦
♦ Make sure that all the attached and related
equipment, such as hoses, water separators and
oilers are properly maintained.

Periodic maintenance

After each operating period of approximately 150
impact hours or twice a year the machine must be
dismantled and all parts be cleaned and checked.
This work must be performed by authorised staff
who are trained for this task.
9800 0798 90e | Original instructions
Safety and operating instructions

Tightening torques

CP 0112 general
A
B
Torque: 115–125 lbf.ft (156–169 Nm)
A.
B. Torque: 80–85 lbf.ft (109–115 Nm)
C. Torque: 65–70 lbf.ft (88–95 Nm)
C
17