Start And Stop; Operating; When Taking A Break; Maintenance - Chicago Pneumatic CP 0112 Instrucciones De Seguridad Y De Funcionamiento

Safety and operating instructions

Start and stop

Model Start
CP 0112
CP 0112 S
CP 0112 EX
Start the machine by pressing down the start and
♦
stop device while firmly holding the handle.
Stop the machine by releasing the trigger. The
♦
start and stop device returns automatically to the
stop position.

Operating

Starting a cut
Stand in a stable position with your feet well away
♦
from the inserted tool.
Press the machine against the working surface
♦
before you start.
Start collaring at such a distance from the edge
♦
that the machine is capable of breaking the
material without levering.
♦ Never try to break off too large pieces. Adjust the
breaking distance (A) so that the inserted tool
does not get stuck.
16
Stop
A
CP 0112, CP 0112 S, CP 0112 EX
Breaking
Let the machine do the work; do not press too
♦
hard.
♦ Avoid working in extremely hard materials for
example granite and reinforcing iron (re-bar)
which would cause substantial vibrations.
Any form of idling, operating without insertion
♦
tool or operating with an uplifted machine must
be avoided.
♦ When the machine is lifted, the start and stop
device must not be activated.
♦ Check regularly that the machine is well
lubricated.

When taking a break

During all breaks you must place the machine in
♦
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
In the event of a longer break or when leaving the
♦
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.

Maintenance

Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
Before starting maintenance on the machine,
♦
clean it in order to avoid exposure to hazardous
substances. See "Dust and fume hazard".
♦ Use only authorised parts. Any damage or
malfunction caused by the use of unauthorised
parts is not covered by warranty or product
liability.
♦ When cleaning mechanical parts with solvent,
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
♦ For major service of the machine, contact the
nearest authorised workshop.
♦ After each service, check that the machine's
vibration level is normal. If not, contact the nearest
authorised workshop.
9800 0798 90e | Original instructions