When Taking A Break; Maintenance; Every Day; Periodic Maintenance - Chicago Pneumatic CP 0006 Instrucciones De Seguridad Y De Funcionamiento

Safety and operating instructions

When taking a break

♦ During all breaks you must place the machine in
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
♦ In the event of a longer break or when leaving the
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.

Maintenance

Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
Before starting maintenance on the machine,
♦
clean it in order to avoid exposure to hazard
substances. See "Dust and fume hazards"
Use only authorised parts. Any damage or
♦
malfunction caused by the use of unauthorised
parts is not covered by warranty or product
liability.
When cleaning mechanical parts with solvent,
♦
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
For major service to the machine, contact your
♦
nearest authorised workshop.
After each service, check that the machine's
♦
vibration level is normal. If not, contact your
nearest authorised workshop.

Every day

Before undertaking any maintenance or changing a
piston on the scabbler, always switch off the air
supply, bleed the machine by depressing the start
and stop device, and disconnect the air hose from
the machine.
♦ Clean and inspect the machine and its functions
each day before the work commences.
Conduct a general inspection for leaks and
♦
damage.
Check that the air inlet nipple is tightened and
♦
that the claw coupling is free from damage.
14
CP 0006, CP 0006 SVR, CP 0066
♦ If the machine has a vibration-reducing handle,
check that it is moving freely (up and down) and
does not jam.
Check that the swivel is moving freely and does
♦
not jam.
Check the condition of the rubber bushing.
♦
Change damaged parts immediately.
♦
Replace worn components in good time.
♦
Make sure that all the attached and related
♦
equipment, such as hoses and water separators,
are properly maintained.

Periodic maintenance

After each operating period of approximately 100
impact hours or three times a year the machine must
be dismantled and all parts be cleaned and checked.
This work must be performed by authorized staff,
trained for this task.

Assembly instructions

CP 0006
9800 0611 90 | Original instructions