Idiomas disponibles
Idiomas disponibles
Special aspects of the alarm
clock
• The alarm signal is repeated after
4 minutes (Autosnooze) unless you
press the Light/Snooze button or the
Wake-up alarm ON / OFF button.
• The lisa vibro time is also used as
a receiver for the lisa light signaling
system.
The 4 signal lamps on the front of
the clock let you know which trans-
mitter signals are active (door,
phone, baby alarm, alarm or pager).
• Like all lisa units, the lisa vibro
time has a channel selection switch
(see also the lisa operating instruc-
tions). This switch is located on the
underside of the unit.
• The quartz mechanism of the
alarm clock has a backup power sup-
ply.
The clock will continue to operate
for about 2 hours if there is a power
failure.
The wake-up alarm function and the
illumination are deactivated during
this period.
• The clock face illumination is also
activated when the alarm is trig-
gered.
• As well as the green marking of
the Alarm ON / OFF switch, the
Snooze button is also illuminated
when the alarm is triggered.
• You can select between two dif-
ferent alarm types.
8 English
The alarm type is altered as descri-
bed below:
-- Switch off the alarm -- Press and
hold the Snooze button for 3 seconds
--
Switch the alarm back on --
The Snooze button flashes to indica-
te that the second alarm type has
been selected.
Maintenance and care
The lisa vibro time does not require
any maintenance. If the unit does
become dirty, simply wipe it clean
with a soft, damp cloth. Never use
spirits, thinners or other organic sol-
vents. Do not set up the unit where
it will be exposed to full sunlight for
long periods. In addition it must be
protected against excessive heat,
moisture and severe mechanical
shock.
Note: This product is not protected
against splash water. Do not place
any containers filled with water,
such as flower vases, or anything
with an open flame, such as a lit
candle, on or near the product.
