Safety Notes; Mounting Instruction - Bosch Rexroth SMibs Manual De Instrucciones

3 609 929 723/1.2 | SMibs
3

Safety Notes

Please keep this Technical Information in a
place easily accessible for all users.
The Technical Information is intended for
specially trained personnel who have a spe-
cialized knowledge of the machine's hard-
ware components.
Repairs or other operations on the hardware
or software of our products, which are not de-
scribed in these instructions, may only be
carried out by Rexroth experts. Unqualified
repairs or operations on the hardware or soft-
ware or the failure to observe the warnings in
these instructions or warnings placed on the
product itself could lead to personal damage
or damage to property.
Qualified personnel are:
– Project personnel, familiar with the safety
regulations of automation systems and
electrical engineering.
– Operators, instructed in the use of the
equipment and having knowledge of the
relevant operational parts of this docu-
mentation.
– Commissioning personnel authorized to
set electric circuits and machines/sys-
tems into operation, earth and mark them,
in accordance with the regulations of se-
curity technology.
Repairs and replacement of parts carried out
by the user are his own responsibility. After
repairing or replacing parts, all prescribed
functional and safety checks must be carried
out.
Electric Drives and Controls | Bosch Rexroth AG 9/28
4

Mounting Instruction

The module is inserted into the system com-
ponents SE302/ KE300.
3 Min
Please take care that the interface module is
completely inserted.
The front knurled bolts must be tightened.
Please take care that the front blind fits close-
ly to BT300.
The power supply of the module takes place
directly with the control unit. Only the data in-
terface is accessible from the outside. The I
B -S-interface module is realized as
TER US
transit interface. In case of open output (un-
connected) it is internally closed with the
bus-end-identification.
Before inserting the
Rexroth interface mod-
ules, the BT 300 card
rack must have been
voltage-free for at least
3 min.
N-