Maintenance And Repairs - SATA jet 1000 A RP/HVLP Instrucciones De Servicio

Operating Instructions SATA Automatic Gun
EN

10. Maintenance and repairs

The following chapter describes the procedures involved for maintaining
and repairing the automatic gun.
Warning!
If maintenance work is performed while the gun is still connected to the
compressed air circuit and material supply, components can unexpect-
edly work loose and material can leak.
→ Empty the automatic gun before all kinds of maintenance work and
then disconnect it from the compressed air circuit and the material sup-
ply.
Incorrect assembly can cause damage to the automatic gun.
→ Fix the automatic gun on a flat surface before all kinds of maintenance
work.
→ Make sure that threads fit properly.
→ Grease all moving parts with SATA high performance grease (Art. No.
48173).
Loose screws can cause damage to parts or result in malfunctions.
→ Tighten all screws by hand and check that they are screwed tight.
Use of the wrong tool can damage the automatic gun. → Only use the
special tool supplied by SATA.
Springs and small parts can fall out during dismantling. The precise instal-
lation position and installation sequence is shown in the figures. Failure to
comply can cause damage to the parts or result in malfunctions.
Spare parts are available for carrying out repairs (see chapter 13).
10.1. Replacing the nozzle set
The nozzle set consists of a tested combination of paint needle [7-5], air
cap [7-7] and fluid tip [7-6]. Always replace the complete nozzle set.
Dismantle the nozzle set
132
Attention!