Nice RC2 Instrucciones Y Advertencias Para La Instalación Y El Uso página 4

To connect the RC2 receiver, the nor-
mal power cable to the equipment to
be controlled must be "interrupted"
(Fig. 1).
WARNING: Electrical systems
must be set up by qualified and
experienced personnel in compli-
ance with current legislation. As
the cable clamps do not provide
protection against pulling and the
removable cable cap can be separated, the RC2 container must be
positioned where it is inaccessible to the general public. Said contain-
er does not guarantee protection against access to those parts of the
system which are live. If the RC2 receiver is installed outdoors, keep
in mind that the cable holders are waterproof only for round cables
with a diameter of 6.5 to 8.5 mm.
01. Make sure there is no voltage anywhere in the electrical circuits.
02. Cut the power cable to the equipment to be controlled.
03. Open the RC2 enclosure and remove the "cable holding cap" (Fig. 2).
04. Strip the sheath off the two ends of the cable approx. 3 cm, then strip
the single conductors approx. 5 mm.
05. Thread the two cables through the holes in the cable holding "cap"
(Fig. 3).
06. Pull the board out a few centimetres (Fig. 4).
07. Connect the conductors to the terminals (Fig. 5).
08. Fold the conductors (Fig. 6).
09. Push the board back inside the enclosure, making sure that the
stripped sections of cable are not exposed, then slide the "cap" along
the cables until the enclosure is closed tight.
10. The RC2 receiver does not require mounting, it can be positioned
2 – English
INSTALLATION
— STEP 3 —
1