TRAPP WM-350 Manual De Instrucciones página 31

✔
There is a support assembled on the lawn
mower handle to facilitate usage and to
prevent the extension cord from being in
the same side of the safety lever.
✔
To use this support, the operator needs to
completely unwind the extension cord
and proceed as follows.
1
11
10
13
Extension Cord Support
2
Fixing the Handle to the Base
6
12
9
7
8
1
2
3
4
5
✔
Bend the extension cord and pass it
through the opening (1) of the support.
After that, loop it around the hook (2).
✔
Allow a loose fit between the safety
support and the switch (3).
3
To fix the handle to the base,
do as follows:
✔
Place the lower left handle (1) into the base
housing fitting (3). Make sure the hole (2) of
the lower handle coincides with the hole (4)
of the base and fix it using the screw (5).
✔
Carry out the same procedure for the lower
right handle.
✔
Get the upper handle (6), place the screw (7)
and tighten it with the butterfly nut (8 and 9).
✔
After handles (1 and 6) are assembled, fix the
handle support
(10) using the
screw (11) and
the nut (12).
5
To fix the
power supply
cord to the
lower handle
(1), use the
clamp (13).
29