Makita DF010D Manual De Instrucciones página 7

To turn on the light, slide the lamp switch to the A
position. To turn off the light, slide the lamp switch to B
position.
Even if you leave the lamp on, the light will automatically
turn off after 5 minutes.
Checking the remaining battery capacity,
auto-stop
The lamp signals by flickering when the battery power is
almost used up during use,.
At this time, recharge the battery or replace the battery
with a fully charged one.
ASSEMBLY
CAUTION:
Always be sure that the lock button is in the locked
•
position B and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit or socket bit
1. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far
as it will go. Then release the sleeve to secure the
bit.
1
008709
2. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit-piece and bit into the
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
1
2
008710
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
1. Bit
1. Bit-piece
2. Sleeve
7
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
OPERATION
The tool can be used in two ways; a straight type and a
pistol type which is selectable according to the
conditions of workplace and screwdriving.
008717
Screwdriving operation
008714
CAUTION:
Adjust the adjusting ring to the proper torque level
•
for your work.
Place the point of the driver bit in the screw head and
apply pressure to the tool. Then switch the tool on.
When the clutch cuts in, the motor will stop automatically.
Then release the switch.
CAUTION:
Make sure that the driver bit is inserted straight in
•
the screw head, or the screw and/or bit may be
damaged.
NOTE:
When driving wood screws, predrill pilot holes to
•
make driving easier and to prevent splitting of the
workpiece. See the chart.