Technical Data; Installation - T.I.P. HWW 6000 EPF Manual De Instrucciones

4. Technical Data

Model
Mains voltage / frequency
Nominal performance
Protection type
Suction port
Pressure port
Max. flow rate (Q )
max
Max. pressure
Max. delivery height (H
Max. suction height
Max. self priming height
Volume tank
Max. size of the solids being pumped
Max. permissible operating pressure
Min. ambient temperature
Min. fluid temperature
Max. fluid temperature (Tmax)
Max. cut-in frequency in one hour
Length of connection cable
Cable type
Weight (net)
Guaranteed sound power level (LWA) 2)
Measured sound power level (LWA) 2)
Sound pressure level (LpA) 2)
Dimensions (L x D x H)
Article no.
1)
The values were determined with free, unreduced in- an outlet.
2) Noise emission values obtained according to the EN 12639 regulation. Measurement method ac-
cording to EN ISO 3744.

5. Installation

5.1. General installation information
During the entire process of installation, the device must not be con-
nected to the electrical mains.
The pump should be installed in a dry place with an ambient tempera-
ture not to fall below 5 °C. The pump and the entire connection system
have to be protected from frost and other climatic influences.
When installing the device, please make sure that the motor is suffi-
ciently ventilated.
22
1)
)
max 1)
HWW 6000 EPF
230 V~ 50 Hz
1,500 Watt
IPX4
39.59 mm (1 ¼" female)
30.93 mm (1 " female)
6,000 l/h
4.5 bar
45 m
9 m
7 m
22 L
3 mm
6 bar
5 °C
2 °C
35 °C
40, evenly distributed
1.5 m
H07RN-F
ca. 15.4 kg
88 dB (A)
86.5 dB (A)
78 dB (A)
48.5 x 27.0 x 63.0 cm
30199
4