Connecting Electrical Projection Screens; Important; Mounting Wall Switch; Wiring (General) - Milestone Projecta Manual Del Usuario

EN
2I L1 1I
2
RF Control
1
2
Wall Switch
6
4
2 P 1
3 4
1
2
Key Switch
1 4
1
10

4.3 Connecting electrical projection screens

1 2 3
4

4.4 Mounting wall switch

➊
1
➋
➌
➍
➎
➏
➐

4.5 Wiring (general)

➀
7
➁
5 ➂
➃
➄
➅
➆
A plug may be connected to the feed wire when using the wall switch. The feed wires
3
may also be connected directly to the electric mains.

4.6 Electrical projection screens without built-in RF remote control

➊
➋
➌

4.7 Connect key switch

Projection screens wider than 5 meters must always be protected from unauthorised
2 3
use. This may be done by using a key operated switch.
Connect the various wires as shown in the diagram.
2 3

Important!

• The connection of the wiring may only be performed by a qualified
electrician.
• Make sure that the circuits which will be worked on are completely
voltage-free before the electrical connections are made.
• Carefully read section 2 'Safety information' first.
First determine the position of the wall switch. Install out of the reach of children
and at a minimum height of 1.5 meters from the floor.
Loosen the rotary knob.
Unscrew the nuts under the rotary knob and remove the mechanism from the case.
Mount the mechanism to the wall with two screws.
Connect the wiring as described in § 4.5 / § 4.6.
Place the case and tighten the nuts.
Place the rotary knob.
Important! Only one projection screen can be connected to one wall
switch.
Wiring
Yellow / Green
Blue
Brown
Brown
Black
Blue
Yellow / Green
Connect the various wires as shown in the diagram.
Replace the case on the wall switch.
Plug the plug into the socket or apply voltage to the circuit concerned again.
In the event of incorrect rotation direction: ensure that the circuit involved is
voltage-free and switch the brown and black motor wires.
Important! Only one projection screens can be connected on to one key
switch.
11
Wall Switch RF Control
4 - Earth
3 - Neutral N - Neutral
P - Live - voltage L - Live - voltage
2 - Down
1 - Up
3 - Neutral
4 - Earth
- Earth