Safety Information; Important Safety Instructions - Milestone Projecta Manual Del Usuario

2 Safety information

EN
6

2.1 Important safety instructions

Observe these instructions to ensure that there is no danger to people. Save these
instructions.
Read these instructions very carefully before installing or using the projection screen.
This is important in order to use the product safely and to prevent personal injury or
other damage.
Observe all installation instructions; incorrect installation may result in serious injury.
• Electrical connections should be performed by a electrician.
• Confirm that the circuits which will be worked on are completely
voltage-free before the electrical connections are made.
See the plate on the projection screen for information on voltage and
maximum power capability.
If you stand facing the projection screen, you will find this information on
the lower left-hand side of the bottom of the case.
• If the projection screen is equipped with a pre-wired plug connection, the plug
must be accessible at all times.
• The (wall) switch for the operation of the projection screen must be placed such
that the movements of the projection screen are visible, yet must remain out of
the range of the projection screen's moving parts.
• The (wall) switch for the operation of the projection screen must be mounted at
least 1.5 meters from the floor.
• The projection screen may not be installed so that when in the down position, it
blocks the view of signs indicating the location of the escape routes nor may it
block access to the escape routes themselves.
• The projection screen may not be installed in front of an air shaft or air
conditioner.
• When installing electrically operated projection screens, use either the wall
switch with automatic zero position which comes with the projection screen,
or a comparable type of switch. The latter switch should only be used after
consultation with a qualifed electrician.
• Standard mounting materials used for mounting the projection screen are
supplied with the projection screen. Each situation should however be evaluated
individually to determine if the materials supplied are satisfactory or if they
should be adapted to the specific situation. For example in situations involving
loose stucco, walls in poor condition or wall systems. In case of doubt, consult a
structural engineer.
• Make sure that the walls and the structural construction are sturdy enough to be
able to support the weight of the projection screen. In case of doubt, consult a
structural engineer.
• For mounting on the wall or ceiling, in addition to the mounting materials
supplied, specially developed accessories are available for use with alternative
mounting methods. For further information, consult your supplier.
• If you discover damage to the projection screen's wiring or case, discontinue the
use of the projection screen immediately and contact your supplier to repair the
damage.
• If the connection cable of the projection screen is damaged, the entire cable must
be replaced by a new cable or motor unit. These components are available from
the manufacturer or from the supplier.
• This appliance is not intended for use by children or adults with restricted
physical, sensory or mental capacities or who lack the relevant experience and/or
knowledge unless they are supervised or instructed by a person responsible for
their safety.
Supervise children to make sure that they do not play with the appliance.
Do not allow children to play with the projection screen. Mount the (wall) switch
out of reach of children or use a key switch (available as an accessory via your
supplier).