Utilitech 148010 Manual De Instrucciones página 8

PROBLEM POSSIBLE CAUSE
Pump runs 1. Float is stuck in the 'on' position.
continuously.
2. Float switch is defective.
Pump runs but 1. Pump is air-locked.
delivers little
water.
2. Vertical pumping distance is too high.
3. Impeller or pump inlet is clogged.
Fuse blows or 1. Impeller or pump inlet is clogged.
circuit breaker
trips when pump
2. Fuse size or circuit breaker may be too
starts.
WARRANTY
This product is warranted for one year from the date of purchase or two years from the date of manufacture,
whichever occurs first. Subject to the conditions hereinafter set forth, the manufacturer will repair or replace
to the original consumer, any portion of the product which proves defective due to defective materials or
workmanship. To obtain warranty service, contact the dealer from whom the product was purchased. The
manufacturer retains the sole right and option to determine whether to repair or replace defective equipment,
parts or components. Damage due to conditions beyond the control of the manufacturer is not covered by this
warranty. For warranty questions or service, call 1-888-566-3597.
THIS WARRANTY WILL NOT APPLY: (a) To defects or malfunctions resulting from failure to properly install,
operate or maintain the unit in accordance with printed instructions provided; (b) to failures resulting from
abuse, accident or negligence; (c) to normal maintenance services and the parts used in connection with
such service; (d) to units which are not installed in accordance with normal applicable local codes, ordinances
and good trade practices; and (e) the unit is used for purposes other than for what it was designed and
manufactured.
RETURN OF WARRANTED COMPONENTS: Any item to be repaired or replaced under this warranty must be
returned to the manufacturer at such place as the manufacturer may designate, freight prepaid.
THE WARRANTY PROVIDED HEREIN IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES, AND MAY
NOT BE EXTENDED OR MODIFIED BY ANYONE. ANY IMPLIED WARRANTIES SHALL BE LIMITED TO
THE PERIOD OF THE LIMITED WARRANTY AND THEREAFTER ALL SUCH IMPLIED WARRANTIES ARE
DISCLAIMED AND EXCLUDED. THE MANUFACTURER SHALL NOT, UNDER ANY CIRCUMSTANCES, BE
LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES, SUCH AS, BUT NOT LIMITED TO
DAMAGE TO, OR LOSS OF, OTHER PROPERTY OR EQUIPMENT, LOSS OF PROFITS, INCONVENIENCE,
OR OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY TYPE OR NATURE. THE LIABILITY
OF THE MANUFACTURER SHALL NOT EXCEED THE PRICE OF THE PRODUCT UPON WHICH SUCH
LIABILITY IS BASED.
This warranty gives you specific legal rights, and you may have other rights which vary from state to
state. Some states do not allow limitations on duration of implied warranties or exclusion of incidental or
consequential damages, so the above limitations may not apply to you.
In those instances where damages are incurred as a result of an alleged pump failure, the
Homeowner must retain possession of the pump for investigation purposes.
small.
CORRECTIVE ACTION
1. Make sure the float can move
freely.
2. Replace pump.
1. Clean out vent hole in discharge
pipe.
2. Reduce the vertical distance to
correspond with the performance
chart in the instructions.
3. Remove pump from basin and
clean impeller or pump inlet.
1. Remove pump from basin and
clean impeller or pump inlet.
2. Electrical circuit capacity must be
15 amps or higher.
8
Printed in China