Kenwood multione KHH30 Manual De Instrucciones página 16

to assemble the food mincer
1 Fit the food mincer scroll
body .
F
2 Fit the cutter – cutting side outermost. Ensure
D
it is seated properly, otherwise you could damage
your food mincer.
3 Fit a screen . Put the notch over the locating
C
tab .
cn
4 Loosely fit the ring nut
to assemble the pasta maker
Optional: for easier pasta making, warm the parts in
hot water before assembling. Then dry thoroughly
before assembling.
1 Fit the pasta scroll
J
body .
F
2 Fit a screen , ,
K L
the locating tab .
co
3 Loosely fit the ring nut
to fit the attachment to the
machine
1 Raise the mixer head.
2 With the attachment in the position shown, align
the drive tabs on the end of the scroll with the
corresponding slots in the bowl tool socket
3 Push the attachment into the socket and turn anti-
clockwise until it locks into place.
4 Hold the feed tube in place and tighten the ring nut
by hand.
5 Fit the tray .
cq
important
Never operate the attachment for longer than 10
l
minutes as this could damage your mixer.
The attachment will not operate unless
l
the dual speed outlet cover is fitted.
to use your food mincer
Thaw frozen food thoroughly before
l
mincing. Cut meat into 2.5cm (1") wide strips.
1 Switch to maximum speed. Using the pusher
gently push the food through one piece at a time.
Do not push hard – you could damage your
food mincer.
2 Once all the food has been minced, switch off and
unplug.
3 Remove the food mincer. Use the spanner
remove the ring nut if it is too tight.
inside the food mincer
E
.
B
inside the food mincer
or . Put the notch over
M N
.
B
to use the pasta maker
1 Make your pasta dough. – a too-dry mix could
break your pasta maker.
2 Switch to maximum speed.
3 Place some of the mix onto the hopper. Feed a
small amount of mix into the feed tube at a time.
Allow the scroll to clear before continuing.
If the feed tube becomes clogged use the end
of the spanner handle
the scroll. Do not push too hard or use the
mincer pusher – you could damage the
pasta maker. Never let the feed tube fill up.
4 When the pasta is long enough, cut to the desired
length.
5 Remove the pasta maker. Use the spanner
remove the ring nut if it is too tight.
Cook rigatoni within 4 hours. Otherwise it will
l
become brittle and snap.
to cook your pasta
1 Bring a pan three quarters full of water to the boil.
Add salt to taste.
2 Add your pasta and gently boil for 3- 8 minutes,
stirring occasionally.
compact chopper/grinder
cm
.
cp
attachment
A jar
B sealing ring
blade unit
C
to use your compact chopper/
grinder
Use the compact chopper/grinder for milling herbs,
nuts and coffee beans.
1 Put the ingredients into the jar
2 Fit the sealing ring
Leaking will occur if the seal is damaged
l
or incorrectly fitted.
,
I
3 Turn the blade unit upside down. Lower it into the
jar, blades down.
4 Screw the blade unit onto the jar until finger tight
. Refer to the graphics on the underside of the
cr
blade unit as follows:
- unlocked position
to
A
- locked position
11
to push the mix onto
A
.
A
into the blade unit
B
to
A
.
C