Install Water Hoses; Coding; Finalising Operations; Place Batteries In The Telestart Hand Transmitter - BMW 5 Serie Manual De Instrucciones

Screw on metering pump (6) with hexagon head
screw and washer (7) M6x20 mm.
Connect fuel connection to the parking heater.

10. Install water hoses

F 39 64 238 R
Prepare coolant hoses taken from the installation
kit as illustrated.
Cut aluminium insulating sleeves to approx. 1000
mm and slide them over the water hoses.
Fit connection pieces (C) as illustrated.
The water hose (1) originally going from cylinder
head to water valve must be cut at approx. 100
mm from the cylinder head (if necessary use hose
clips to avoid coolant coming out).
Install pre-prepared coolant hoses (as shown)
without kinks and fix them in position with cable
ties at appropriate places (e.g. brake lines).
To make it easier to evacuate air from the
system it is advisable to fit the water hoses first
to the cylinder head and to the heater valve.
Before connecting the last coolant hose, fill
parking heater and cooling system with coolant.
= Coolant hoses parking heater entry
= Coolant hoses parking heater exit
= Hose pieces are not required

11. Coding

No coding with DIS or MoDIC is required for this
retrofit package.

12. Finalising operations

Mark year of installation on identification plate of
parking heater.
The date of installation must remain readable,
i.e. only the year numbers which do not
correspond to the year of installation may be
removed.
Fill coolant system, start engine and put vehicle
heater on warm (max.).
Let the engine run for approx. 5 minutes
with 3000 1/min. Switch on park heating after
approx. 5 minutes with the engine already running
(see chapter Initialise Telestart hand transmitter).
Leave the engine and park heating running until
warm air comes out of the air outlet nozzles in
the interior.
Turn engine off, pressure test cooling water circuit
and test for leaks.
26
13. Place batteries in the Telestart
hand transmitter
F 39 64 111 R
Putting the batteries in:
Open the battery compartment of the Telestart
hand transmitter. Place two ordinary 1.5 Volt
batteries (type LR 1) in the battery compartment
as shown. Close the battery compartment again.
Checking the batteries:
Press the Off-button on the Telestart hand
transmitter.
The batteries are in order if the switching-on
check LED blinks 3 times
Hand in used batteries at a collecting
point or at your BMW Service centre.
14. Initialise Telestart hand
transmitter
Each Telestart receiver can be allotted up to
2 Telestart hand transmitters.
!
Do not pull out antenna in immediate vicinity
(less than 3 m).
F 36 64 963 R
Interrupt voltage supply of the Telestart receiver by
pulling out the 20 A blade terminal fuse in the fuse
box of the park heating for at least 10 seconds.
Put blade terminal fuse back again and within 3
seconds of doing so briefly (for 1 second) activate
the Off-button (2) on the Telestart hand transmitter.
Wait for 3 seconds.
Within a further 5 seconds press the Start-button (1)
briefly (1 second).
The switching-on check LED starts to blink.
Wait 3 seconds.
Within a further 5 seconds press the Off-button (2)
briefly (1 second).
The switching-on check LED stops blinking.
Initialisation is concluded.
If any of the given periods has been exceeded or
fallen short of, the initialisation must be repeated in
its entirety.
Initialisation of a further Telestart hand transmitter
is carried out in the same way.