Hilti GX 2 Manual Del Usuario página 27

10.2 Cleaning the fastening tool
Note
The fastening tool must be cleaned and serviced regularly. We recommend that a cleaning service is
carried out, at the latest, after driving 25,000 fasteners.
▶ Clean the fastening tool, or have it cleaned, if malfunctions such as misfiring occur increasingly.
▶ For cleaning, use the cleaning set (available as an accessory) and observe the illustrated cleaning
instructions enclosed with it.
10.3 Maintenance
▶ To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Center or online at: www.hilti.group.
▶ Check all external parts of the fastening tool for signs of damage at regular intervals and make sure that
all the controls function correctly.
▶ Do not use the fastening tool if parts are damaged or if the controls do not function correctly.
▶ Have a defective fastening tool repaired by Hilti Service.
10.4 Checks after care and maintenance work
▶ After maintenance, check that the fastener guide is fitted → page 22.
11 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Malfunction
Fasteners are frequently
driven to inadequate depth.
Fasteners are frequently
driven too deeply.
Fasteners break.
Printed: 11.09.2017 | Doc-Nr: PUB / 5336064 / 000 / 02
Possible cause
Driving power is too low.
The fasteners are too long.
The supporting material is too
hard.
Driving power is too high.
The fasteners are too short.
Driving power is too low.
The fasteners are too long.
The supporting material is too
hard.
The fastener guide is not held per-
pendicular to the working surface.
Action to be taken
▶ Move the fastener driving depth
adjustment slider to the + position.
▶ Use shorter fasteners.
▶ Consider using a DX fastening
tool.
▶ Move the fastener driving depth
adjustment slider to the ‒
position.
▶ Use longer fasteners.
▶ Move the fastener driving depth
adjustment slider to the +
position.
▶ Use shorter fasteners.
▶ Consider using a DX fastening
tool.
▶ On an even surface use the
support leg and ensure correct
contact with the surface (see
"Support leg" → page 18).
English 23