Repair - Bosch TPA 200 Manual Original

Tire pressure sensor position for programming
¶
Place TPA 200 and tire pressure sensor on a
flat work surface.
i
The best results are achieved if the tire pres-
sure sensor is placed at a distance of 2 cm to
5 cm in front of TPA 200.
i
The programming of a tire pressure sensor can
be disrupted by the surrounding tire pressure
sensors. Surrounding tire pressure sensors
must be removed during the programming.
5.6

Repair

With this function a retest of the tire pressure
sensors can be carried out after a repair (e.g. a
tire pressure sensor has been replaced).
1. Switch on the TPA 200.
 Main Menu
is displayed.
 Check
is displayed.
2. Select "Repair" with
 Vehicle >New Vehicle
in the case of operation sequence "None").
i
If tests on vehicles have already been
performed and saved, and if the operation
sequence is set for "Job code", "Registration"
or "Model Year", these vehicles can be se-
lected again and tested.
3. Confirm with .
 Select Make
4. Select " Select Make" with
confirm with .
 Select Model
5. Select " Select Model" with
confirm with .
 Select Year
6. Select " Select Year" with
confirm with .
i
During the work flow "Job code", the job
number of the vehicle to be tested can be en-
tered "Registration" before the tire pressure
sensor test with
with and the license number of the vehicle
to be tested can also be entered.

Front Left >Read Sensor
Robert Bosch GmbH
or and confirm with
is displayed (not
is displayed.
or and
is displayed.
or and
is displayed.
or and
or and then confirm
is displayed.
Operation | TPA 200 | 27
The following menu items can be selected:
Menu item
>Read Sensor
>Req. Repair
>Skip Wheel
>Cancel Audit
7. Hold the TPA 200 close to the tire valve.
 Front Left >Read Sensor
played.
8. Confirm with
 Tire pressure sensor is read out and sub-
sequently displays the data of the tire
pressure sensor, e.g.
2.5bar Bat:OK
ID:00001A635
i
In case the tire pressure sensor could not be
read out, repeat the search
9. Confirm with
. 10. Read out the tire pressure sensors of all the
wheels according to the indicated sequence.
11. Confirm with
 Vehicle Data >Save
The following menu items can be selected:
Menu item
Vehicle Data
>Save
Vehicle Data
>Edit
Vehicle Data
>Exit

Vehicle Data >Save
 Confirm with
"
Measured data of the tire pressure sensors
are saved.
" Main Menu
Description
Tire pressure sensor is read out.
Select only if the tire pressure sensor
is visibly faulty. A message about re-
pair is made in the test protocol. The
tire pressure sensor is not read out.
The selected tire pressure sensor is
not read out.
Return to the main menu. No data is
saved.
.
.
.
is displayed.
Description
The measurement data is saved.
The individual tire pressure sen-
sors can be marked with
whether they should be repaired. The
message about repair is then made in
the test protocol. Order numbers or
license numbers can also be edited.
The measurement data is not saved.
is displayed.
.
is displayed.
|
1 689 989 200 2016-02-16
en
is dis-
, showing