Electrolux EOC55200 Manual De Instrucciones página 15

Stainless steel or aluminium appli-
ances:
Clean the oven door with a wet sponge
only. Dry it with a soft cloth.
Do not use steel wool, acids or abra-
sive materials as they can damage the
oven surface. Clean the oven control
panel with the same precautions
PYROLYTIC CLEANING
1. Remove all removable parts and ex-
cess spillage from the oven.
If you do not remove the shelf support
rails, the clock display shows "AS" and
the pyrolytic cleaning procedure cannot
start.
2. Remove the worst residual dirt manual-
ly.
3. Turn the knob for the oven functions to
.
– "Pyro" appears on the display,
– Duration
ly 5 seconds.
The pyrolytic cleaning process lasts ap-
proximately 2 h 30 min. If you want it to
end at a specific time, press the Selec-
tion button until the End
dicator flashes. Use the + / - control
knob to set the end time for the proce-
dure. The function calculates the start
time based on the end time you speci-
fy. The pyrolytic cleaning then starts
and ends at the required time.
4. Press the Pyro button. The pyrolytic
cleaning starts.
5. At the end of the process, an acoustic
signal sounds and "0.00" appears on
the display. Duration
proximately 5 seconds. Turn the oven
control knob to 0.
During the pyrolytic cleaning the light
does not operate.
When the oven reaches the set tem-
perature, the door locks.
The bars of the heat indicator come up
until the door unlocks again.
PYRO REMINDER
The reminder function tells the user when
pyrolytic cleaning is necessary.
flashes for approximate-
function in-
flashes for ap-
An acoustic signal sounds and the display
shows "Pyro" for approximately 15 sec-
onds.
Set the Pyrolytic cleaning function.
The display shows the reminder mes-
sage when the appliance is off until you
clean the appliance with the Pyrolytic
cleaning.
SHELF SUPPORT RAILS
Removing the shelf support rails
1. Pull the front of the shelf support rail
away from the side wall.
2. Pull the rear shelf support rail away
from the side wall and remove it.
2
1
Installing the shelf support rails
Install the shelf support rails in opposite se-
quence.
The rounded ends of the shelf support
rails must point to the front!
electrolux 15