Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Set the Time of Day and Date
If this is the first time the timer has been programmed, you should press the small
recessed button labeled reset. Pressing reset does not affect the factory installed
fail-safe program. [See Figure 2]
Do not press the reset button again unless you want to completely remove all your
programming.
• Turn the rotary dial to the time/date position.
• 12:00 AM will appear in the display with three arrows pointing to the year, month,
and day [See Figure 3].
• Press and hold the + button to advance the clock to the correct time of day. Use
the – button to go in reverse. When the correct time of day is reached, press the
enter button to lock in the time. To increase or decrease more rapidly, hold down
either the + or – buttons until the display goes into rapid advance mode.
• A blinking cursor will appear below the arrow for the year, month, and date
when programming.
• Use the + and – buttons to set the correct year, then press enter.
Figure 3: LCD Display with Surrounding Information
8
Tabla de contenido
