Types Of Work; Care And Maintenance - Hilti TE 700-AVR Manual De Instrucciones

5.5 Positioning the chisel
Note
The chisel can be adjusted to 24 different positions (in 15° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
▶ Set the function selector switch to
5.6 Locking the chisel
▶ Set the function selector switch to
5.7 Setting the chiseling power
Note
Chiseling power can be reduced to approx. 70% by pressing the power level selector switch. The
power level LED then lights up, indicating reduced power.
Chiseling power can be adjusted only when the power tool is switched on and ready for use. To
reselect full chiseling power, press the chiseling power level selector switch again. Switching off and
then on again also causes the power tool to return to full chiseling power.
▶ Press the power level selector switch.

6 Types of work

WARNING
Risk of electric shock! Severe injury and burns can result if any attempt is made to operate the tool
without an earth/ground conductor and ground fault circuit interrupter correctly connected.
▶ Irrespective of whether mains power or generator power is used, always make sure that an
earth/ground conductor and ground fault circuit interrupter are present in the power supply and
that these are correctly connected.
▶ Do not use the product unless these safety measures are in place and fully operational.
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Chiseling 6
▶ Set the function selector switch to the

7 Care and maintenance

WARNING
Danger of electric shock! Carrying out care and maintenance while the supply cord is connected to
the power outlet presents a risk of serious injuries including burns.
▶ Always unplug the supply cord before carrying out all care and maintenance tasks.
Care
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
they can attack the plastic parts.
Printed: 11.04.2017 | Doc-Nr: PUB / 5071171 / 000 / 05
5
and position the chisel as desired.
and rotate the chisel until it engages.
position.
English 17