Power-Cord Caution - Pioneer DJM-750 Guia De Inicio Rapido

CAUTION
The POWER switch on this unit will not completely
shut off all power from the AC outlet. Since the power
cord serves as the main disconnect device for the
unit, you will need to unplug it from the AC outlet to
shut down all power. Therefore, make sure the unit
has been installed so that the power cord can be
easily unplugged from the AC outlet in case of an
accident. To avoid fire hazard, the power cord should
also be unplugged from the AC outlet when left
unused for a long period of time (for example, when
on vacation).
WARNING
Store small parts out of the reach of children and
infants. If accidentally swallowed, contact a doctor
immediately.

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the
plug by tugging the cord and never touch the power
cord when your hands are wet as this could cause a
short circuit or electric shock. Do not place the unit, a
piece of furniture, etc., on the power cord, or pinch the
cord. Never make a knot in the cord or tie it with other
cords. The power cords should be routed such that they
are not likely to be stepped on. A damaged power cord
can cause a fire or give you an electrical shock. Check
the power cord once in a while. When you find it
damaged, ask your nearest PIONEER authorized
service center or your dealer for a replacement.
LINE VOLTAGE SELECTOR SWITCH
The line voltage selector switch is located on the side panel of this
mixier.The factory setting for the voltage selector is 220-240V. Check
that it is set properly before plugging the power cord into the outlet.
If the voltage is not properly set or if you move to an area where the
voltage requirements differ, adjust the selector switch as follows:
Use a medium-sized (flat blade) screwdriver. Insert the tip of the
screwdriver into the groove of the selector switch and set it so that
the power voltage marking of your area points to the arrow.
110-120V 220-240V
VOLTAGE
SELECTOR
For Taiwan, please set to 110-120V before using.
For Taiwan exclusively
Taiwanese two pin flat-bladed plug
D3-4-2-2-2a*_A1_En
D41-6-4_A1_En
S002*_A1_En
K056_A1_En
3
En