Petsafe WORKLIGHT Manual Del Usuario página 19

The Receiver
Collar is beeping
everywhere.
The Receiver
Collar is beeping
but my pet is not
responding to the
Static Correction.
• Check that the Transmitter is plugged
into a working standard 120-volt outlet,
turned on, the Power Light is on, and the
Transmitter controls are set at your desired
settings.
• Bring Receiver Collar while standing within
5-10 feet of the Transmitter to reset.
• Re-Synchronize the System. (Page 22)
• Make sure the Static Correction Level is set
at 2 or above.
• Test the Receiver Collar with the Test Light.
• If the Test Light flashes, check the fit of the
Receiver Collar.
• Trim your pet's fur where the Contact Points
touch the neck and/or switch to the longer
Contact Points.
• Increase the Static Correction Level.
• Repeat training steps to reinforce training.
www.petsafe.net 19