Maintenance And Cleaning - Würth EBS 125-E Traducción Del Manual De Instrucciones De Servicio Original

Removing:
▸
Lock spindle [13] .
▸
Remove the clamping nut [17] by turning it an-
ti-clockwise using the 2-hole wrench[18].
Operation
Working near to walls
WARNING !
Risk of severe injuries.
Remove the mains plug before
¾
opening and closing the tool. The
accessory must be stationary.
Fold up the segment [1] only when working close
¾
to walls, for all other work the segment [1] must
be folded down.
The open area of the protective guard [8] must
¾
point towards the wall.
Setting the speed
▸
Set the optimum speed for the application at
setting wheel [6].
For most applications, a setting wheel position
3
between 4 and 6 is appropriate.
Switching ON/OFF
WARNING !
Risk of severe injuries.
Always guide the machine with both
¾
hands.
First switch on, then bring the
¾
attachment into contact with the
workpiece.
WARNING !
Danger of unintentional starting
Always switch off the machine when
¾
the mains plug is removed from the
plug socket or if a power failure has
occurred.
Risk of a dust explosion.
Take care to prevent the machine
¾
from drawing in additional dust and
chips.
Keep away from dust deposits when
¾
switching the machine ON and OFF.
DANGER !
WARNING !
Risk of severe injuries.
If the machine is set to continuous run-
Â
ning, it will continue to run if it is torn
out of your hand.
Always hold the machine with both
¾
hands at the handles provided, take
up a stable posture and concentrate
on the work in hand.
Switch ON
▸
Push the trigger switch [7] forwards. For contin-
uous operation, then press downwards until it
engages.
Switch OFF
▸
Press the rear end of the trigger switch [7] and
release.

Maintenance and cleaning

WARNING !
Danger posed by electric current.
Carry out maintenance and cleaning
¾
work on the device only when the
mains plug has been removed.
Motor cleaning
▸
Blow out the machine with compressed air through
the rear ventilation slots regularly, frequently and
thoroughly. Hold the machine firmly while blowing
out.
Replace spring-loaded brush ring
▸
Replace a worn brush ring [14] to ensure op-
timum dust extraction.
Risk of injuries or property damage due
to improper actions.
Do not open the device.
¾
The device must only be opened by a
¾
Würth service technician.
Observe the relevant safety and
¾
accident prevention regulations
during all maintenance and servicing
work.
CAUTION !
19