Tabla de contenido
EQUIPMENT AND ACCESSORIES
1.
Drill chuck + key
2.
Auxiliary handle
3.
Additional handle
4.
Depth gauge rod
5.
Hexagonal key
6.
Flat spanner
7.
Reducer sleeve
8.
Transport case
INSTALLATION OF THE HANDLE
Due to personal safety issues it is recommended to use the additional or auxiliary handle.
INSTALLATION OF AUXILIARY HANDLE
Auxiliary handle is used when the tool operates in mixer mode.
Loosen screws on the mixer drill body.
Slide the auxiliary handle rod ( 8) into the hollow in the mixer drill body (fig. A).
Tighten loosened screws to secure the auxiliary handle.
Deinstallation of the auxiliary handle is similar to installation, only the sequence of actions is reversed.
INSTALLATION OF MIXER
Install reducer sleeve (7) on the mixer drill spindle (6), tighten with flat spanners (included) (fig. B).
Screw the mixer shaft into the reducer sleeve ( 7).
INSTALLATION OF ADDITIONAL HANDLE
Additional handle is used when the tool operates in drill mode.
Possibility to rotate the additional handle (2) before it is clamped on the mixer drill body allows choosing
the position most comfortable for specific working conditions.
Loosen the wheel lock that locks collar of the additional handle (2) by turning it left.
Slide the additional handle collar over cylindrical part of the mixer drill body.
Turn for the most comfortable position.
Turn the handle lock tight to the right to clamp the additional handle.
DEPTH GAUGE INSTALLATION
Depth gauge (5) is used to limit the depth of drill penetration of material.
Loosen the wheel lock, which blocks collar of the additional handle ( 2).
Slide depth gauge rod ( 5) into the hole in the additional handle collar (2).
Set desired drill depth.
Fix by tightening the additional handle wheel lock.
DRILL CHUCK INSTALLATION AND REMOVAL
Drill chuck is fixed directly on the mixer drill spindle.
Open drill chuck ( 1) jaws.
Unscrew the drill chuck fixing screw with cross screwdriver, by turning it clockwise (left-hand thread).
Install hexagonal key in the drill chuck ( 1) (fig. C).
Hold the spindle with flat spanner and gently tap the end of the hexagonal key.
Unscrew the drill chuck.
Installation of the drill chuck is similar to deinstallation, only the sequence of actions is reversed.
- 1 pce
- 1 pce
- 1 pce
- 1 pce
- 1 pce
- 2 pcs
- 1 pce
- 1 pce
PREPARATION FOR OPERATION
12
12
Tabla de contenido
