Preparation For Operation - GRAPHITE 58G862 Instrucciones De Uso

Use the power tool according to the manufacturer's instructions only.
DESCRIPTION OF DRAWING PAGES
Below enumeration refers to the device elements depicted on the drawing pages of this manual.
1. SDS-PLUS chuck
2. Fixing sleeve
3. Drilling mode switch
4. Lid for greasing inlet
5. Switch
6. Impact mode switch
7. Bottom engine casing
8. Additional handle
9. Depth gauge rod
* Differences may appear between the product and drawing
MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Drill
2. Chisel
3. Depth gauge
4. Dust cover
5. Grease container
6. Additional handle
7. Special key
8. Transport case
INSTALLATION OF ADDITIONAL HANDLE
Due to safety issues, always use additional handle (8) when operating the hammer drill. It can be
fixed in any chosen position.
Loosen the wheel lock that locks collar of the blocking handle (8) by turning it counter-clockwise.
Slide the handle collar over cylindrical part of the hammer drill body.
Turn for the most comfortable position.
Turn the wheel lock clockwise tight to clamp the handle (8).
DEPTH GAUGE ROD INSTALLATION
Depth gauge (9) serves to limit the depth of drill penetration of material.
Loosen the butterfly nut on the additional handle collar (8).
Slide depth gauge rod (9) into the hole in the additional handle collar.
Set desired drill depth.
Tighten the butterfly nut.
- 1 pce
- 1 pce
- 1 pce
- 1 pce
- 1 pce
- 1 pce
- 1 pce
- 1 pce

PREPARATION FOR OPERATION

13