Safety Instructions - Tripp-Lite B043-DUA8-SL Manual Del Propietário

Safety Instructions

• Read all of these instructions and save them for future reference.
• Follow all warnings and instructions marked on the device.
• Do not place the device on any unstable surface (cart, stand, table, etc.). If the device falls,
serious damage will result.
• Do not use the device near water.
• Do not place the device near, or over, radiators or heat registers. The device cabinet is provided
with slots and openings to allow for adequate ventilation. To ensure reliable operation, and to
protect against overheating, these openings must never be blocked or covered.
• The device should never be placed on a soft surface (bed, sofa, rug, etc.), as this will block
its ventilation openings. The device also should not be placed in a built-in enclosure, unless
adequate ventilation has been provided.
• Never spill liquid of any kind on the device.
• Unplug the device from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use
a damp cloth for cleaning.
• The device should be operated from the power source type as indicated on the marking label. If
you are not sure of the type of power available, consult your dealer or local power company.
• Do not allow anything to rest on the power cord or cables. Route the power cord and cables so
that they cannot be stepped on or tripped over.
• If an extension cord is used with this device, make sure that the total of the ampere ratings of all
products used on this cord does not exceed the extension cord ampere rating. Make sure that
the total of all products plugged into the wall outlet does not exceed 15 amperes.
• Position system cables and power cables carefully; be sure that nothing rests on any cables.
• To help protect your system from sudden transient increases and decreases in electrical power, it
is recommended that you plug your devices into a Tripp Lite Surge Protector, Line Conditioner, or
Uninterruptible Power Supply (UPS).
• When connecting or disconnecting power to hot-pluggable power supplies, observe the following
guidelines:
o Install the power supply to the unit before connecting the power cable to the power supply.
o Unplug the power cable before removing the power supply.
o If the system has multiple sources of power, disconnect power from the system by unplugging
all power cables from the power supplies.
• Never push objects of any kind into or through the housing slots. They may touch dangerous
voltage points or short out parts resulting in a risk of fire or electrical shock.
• Do not attempt to service the device yourself. Refer all servicing to qualified service personnel.
• If the following conditions occur, unplug the device from the wall outlet and bring it to qualified
service personnel for repair.
o The power cord or plug has become damaged or frayed.
o Liquid has seeped into the device.
o The device has been exposed to rain or water.
o The device has been dropped, or the housing has been damaged.
o The device exhibits a distinct change in performance, indicating a need for service.
o The device does not operate normally when the operating instructions are followed.
• Only adjust those controls that are covered in the operating instructions. Improper adjustment of
other controls may result in damage that will require extensive work by a qualified technician to repair.
• Use of this equipment in life support applications where failure of this equipment can reasonably
be expected to cause the failure of the life support equipment or to significantly affect its safety
or effectiveness is not recommended.
18-09-501-9338C1.indb 4
4
11/2/2018 3:01:49 PM