Vacuuming Up Liquids - Hilti VC 30L Manual De Instrucciones Original

1. Before plugging the supply cord into a power outlet, check that the function selector switch is in the OFF
position.
2. Plug the vacuum cleaner's supply cord into the power outlet.
3. Turn the control switch to the ON position.
8.3 Using electric tool power outlet
The power outlet on the appliance is to be used only for powering electric tools directly from the
vacuum cleaner.
The operating instructions and safety instructions for the electric tool plugged into the power outlet on
the vacuum cleaner must be observed.
The vacuum cleaner will continue to run for a short time after the electric tool is switched off in order
to ensure that all dust is removed from the suction hose.
1. Unplug the vacuum cleaner's supply cord from the power outlet.
2. Check that the maximum power drawn by the electric tool is below the maximum permissible output of
the power outlet on the vacuum cleaner (please refer to the "Technical data" section of the operating
instructions and information printed at the power outlet on the appliance).
3. Check to ensure that the electric tool is switched off before plugging its supply cord into the power outlet.
4. Plug the electric tool's supply cord into the power outlet on the vacuum cleaner.
5. Plug the vacuum cleaner's supply cord into the power outlet.
6. Turn the control switch to the AUTO position.
7. Switch on the power tool.
8.4 Vacuuming up dry dust
Before vacuuming up dry dust, especially dust from mineral materials, always check to ensure that
the correct dust bag is fitted in the container. The material vacuumed up by the vacuum cleaner can
then be disposed of cleanly and easily.
▶ Check that the filter element is dry and that the correct type of dust bag is fitted.
8.5

Vacuuming up liquids

8.5.1 Preparation and performance of the task
If possible, use a separate filter element for wet applications.
1. Remove the dust bag from the waste material container.
2. Check the float of the fill level monitor; clean the float if necessary.
3. Take note of changes in suction power when vacuuming is in progress, for example when the fill level
monitor trips.
8.5.2 Fill level monitor trips
When the waste material container fills up to the maximum fill level the fill level monitor trips. Empty the
waste material container to be able to resume operation.
When large quantities are vacuumed up, liquid can build up in the filter and restrict operation of the
float. At regular intervals, allow all liquid to drain out of the filter.
1. Turn the control switch to OFF.
2. Disconnect the supply cord plug from the power outlet.
3. Open the 2 container latches.
4. Lift the suction head off the waste material container and place the waste material container on a level
surface.
5. Grip the waste material container by the recess provided and empty it by tipping out the contents.
6. Check the float of the fill level monitor; clean the float if necessary.
22 English 2297598
*2297598*