Testing And Adjustments - Heath Zenith 4392 Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

WIRING
WARNING: Turn power off at circuit
breaker or fuse.
Note: All wiring should be run in accordance with
the National Electrical Code through conduit or
another acceptable means. Contact a qualified
electrician if there is any question as to the
suitability of the system.
Note: We recommend having an assistant help hold
the sensor assembly during the wiring process.
1. Using the wire nuts included, connect the wires
as shown below.
Black to Black
White to White
Connect Sensor Assembly Wires to Post Wires
2. Install a medium base light bulb into socket
(100 Watts maximum, not included).
Note: Do not screw sensor assembly onto light
post until after completing the steps under Testing
and Adjustments.
1. Turn on the circuit breaker and light
2. Set:
Sensor Assembly
Green Sensor
Wire to Green/
Bare Ground
Post Wire
Existing Light
Post
3. Place the sensor assembly snugly onto light
4. Walk through the coverage area noting where you
5. Adjust the SENSITIVITY to increase or de-
2

TESTING AND ADJUSTMENTS

switch.
Note: Sensor has a 1
before it will detect motion. When first turned on
wait 1
/
minutes.
1
2
ON-TIME switch to TEST
D
B
switch to OFF
®
ual
rite
SENSITIVITY dial to Midway
ON TIME
MINUTES
TEST
1
AUTO
5
10
DUSK TO
DAWN
6 HOUR
3 HOUR
OFF
D
B
UAL
RITE
post ensuring that wires are not pinched.
are when the lights turn on. In TEST mode, light
will stay on for 5 seconds after sensing motion
and then turn off.
Note: Remove sensor assembly from light post
to make adjustments as needed.
crease the range as needed. Too much sen-
sitivity may cause false triggering due to heat
sources in the coverage area (see Adjustment of
Coverage Area or Troubleshooting section).
/
minute warm up period
1
2
MIN
MAX
SENSITIVITY
200067-03
Tabla de contenido
loading

Tabla de contenido