Kenwood FDP30 Manual De Instrucciones página 5

Do not use the lid to operate the processor, always use the on/off speed
l
control.
This appliance will be damaged and may cause injury if the
l
interlock mechanism is subjected to excessive force.
Always unplug your food processor when not in use.
l
Never use an unauthorised attachment.
l
Never use a damaged appliance. Get it checked or repaired: see "service
l
and customer care".
Never let the power unit, cord or plug get wet.
l
Do not let excess cord hang over the edge of a table or worktop or touch
l
hot surfaces.
Children should be supervised to ensure that they do not play with the
l
appliance.
This appliance shall not be used by children. Keep the appliance and its
l
cord out of reach of children.
Appliances can be used by persons with reduced physical, sensory or
l
mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe
way and if they understand the hazards involved.
Only use the appliance for its intended domestic use. Kenwood will not
l
accept any liability if the appliance is subject to improper use, or failure to
comply with these instructions.
Misuse of your processor, blender or mill can result in injury.
l
The maximum rating is based on the attachment that draws the greatest
l
load. Other attachments may draw less power.
blender
DO NOT process hot ingredients.
l
SCALD RISK: Hot ingredients must be allowed to cool to room
l
temperature before placing in the goblet or before blending.
Always take care when handling the blade assembly and avoid touching
l
the cutting edge of the blades when cleaning.
Only operate the blender with the lid in place.
l
Only use the goblet with the blade assembly supplied.
l
Never run the blender empty.
l
To ensure the long life of your blender, do not run it for longer than 60
l
seconds.
Smoothie recipes - never blend frozen ingredients that have formed a solid
l
mass during freezing, break it up before adding to the goblet.
mill attachments
Never fit the blade assembly to the power unit without the jar/lid fitted.
l
Never unscrew the jar/lid while the mill is fitted to your appliance.
l
3