Package Contents; Description (Fig. A); Electrical Safety - DeWalt DC610 Manual De Instrucciones

+40 ˚c
+4 ˚c
Charge only between 4 °C and 40 °C
Discard the battery pack with due care
for the environment
Do not incinerate the battery pack
NiMH
+
NiCd
Charges NiMH and NiCd battery packs
See technical data for charging time
Additional safety instructions for cordless nailers
• Always wear safety glasses.
• Always wear ear protection.
• Only use fasteners of the type specified in
the manual.
• Do not use any stands for mounting the tool
to a support.
• Do not disassemble or block any parts
of the fastener driving tool such as the safety yoke.
• Prior to each operation check that the safety
and triggering mechanism is functioning properly
and that all nuts and bolts are tight.
• Do not use the tool as a hammer.
Do not use the tool on a ladder.
• Never point any operational fastener driving tool
at yourself or at any other person.
• While working, hold the tool in such a way that
no injuries can be caused to the head or to the
body in the event of a possible recoil due to a
disruption in the energy supply or hard areas
within the workpiece.
• Never actuate the fastener driving tool into free
space.
• In the work area, carry the tool at the workplace
using only one handle, and never with the trigger
actuated.
• Consider the conditions in the work area.
Fasteners can penetrate thin workpieces or slip
off corners and edges of the workpiece, and thus
put people at risk.
• Do not drive fasteners close to the edge of the
workpiece.
• Do not drive fasteners on top of other fasteners.

Package contents

The package contains:
1 Nailer
1 Charger (DC618)
2 Battery packs (DC618)
1 Safety glasses
1 Kitbox (K-models only)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.

Description (fig. A)

Your nailer DC610/DC618 has been designed for
driving fasteners into wooden workpieces.
1 On/off switch
2 Contact trip lock-off
3 Depth adjustment wheel
4 Headlights
5 Contact trip
6 Magazine
7 Mode selector switch
8 Belt hook
9 Battery pack
Charger
Your charger DE9116 accepts DeWALT NiCd/NiMH
battery packs ranging from 7.2 to 18 V.
9 Battery pack
10 Release buttons
11 Charger
12 Charging indicator (red)

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
E N G L I S H
29