Seca 242 Manual De Instrucciones Y Garantía página 23

Switching off the measuring rod
– To switch off the measuring rod, press
the START key again.
If the measuring rod is no longer being
used, it switches off automatically after
5 minutes.
After measuring, push the head stop back up to prevent injuries occurring.
Selecting a channel – if you have two measuring rods
To operate two measuring rods simultaneously in the same reception area, the channel for
radio transmission on the display unit and the slide unit can be switched.
For transmission to function, the channels on the display unit and the slide unit
must match.
Channel "B" is always selected when the measuring rod is delivered. To switch the chan-
nel, proceed as follows:
– Move the slide unit.
– Keep the DATA VALID key depressed
for at least 5 seconds. The module is
switched to the other channel.
– Keep the cm/ins key on the display unit
depressed and switch it on.
The channel of the display unit is switched.
The active channel is displayed for 2 sec-
onds (e.g. CH B).
Note: it may be necessary to re-set the channel after the batteries in the slide unit
have been changed.
Your measuring rod is mobile ... (
It has two castors at the back.
– For mobile use, the seca 245 can be
tilted slightly backwards and then
moved on its castors.
Model 242/245
only)
seca 245
GB 23