Adjusting The Angle Of The Display - SonoSite SiteStand Manual Do Usuário

To connect the ball-type mount display to the SiteStand:
Knob

Adjusting the Angle of the Display

The display should be adjusted to the proper angle prior to use.
The procedure is different for each display type. Locate the procedure below that matches your
display type.
22
Chapter 3: Using the Accessories
1
Caution: To prevent damaging the display, verify
that the display is properly seated prior to tightening
the knob.
2
3
Ferrite bead
Insert the display onto the top end of the bracket.
Tighten the knob located on the back of the
display to secure it to the bracket.
Attach the end of the composite video cable that
has a ferrite bead to the connector labeled "comp
video" on the back of the display.