Attaching The Display To The Sitestand - SonoSite SiteStand Manual Do Usuário

Attaching the Display to the SiteStand

There are two types of mounts, the cylinder-type and the ball-type. Examine the display prior to
mounting to determine which type you have. Both types are pictured below.
To connect the cylinder-type mount display to the SiteStand:
Tighten only the lower set screw
Ferrite bead
Insert the display onto the top end of the bracket.
1
Caution: To prevent damaging the display, verify
that the display is properly seated prior to tightening
the set screw.
Tighten the lower set screw, located on the
2
display bracket, to secure the display to the
SiteStand.
Caution: The upper set screw is preset. Do not
adjust it.
Attach the end of the composite video cable (C)
3
that has a ferrite bead to the connector labeled
"comp video" on the back of the display.
Chapter 3: Using the Accessories
21