Replacing The Electrical Fuse - SonoSite SiteStand Manual Do Usuário

Replacing the Electrical Fuse

To replace the electrical fuse:
Disconnect the AC line cord from the hospital-grade electrical outlet.
1
Disconnect the AC line cord from the bottom of the SiteStand.
2
Use a small, slotted screwdriver to remove the fuse drawer (located directly below the input AC
3
connector) on the SiteStand.
You should identify the cause of the blown fuse prior to plugging the SiteStand
Caution:
back into AC power.
Carefully replace the blown fuse with a 250 volt, 6.3 amp, 5.0 x 20 mm Slo-Blo
4
Install the fuse drawer.
5
Connect the AC power to the SiteStand.
6
Video output connector
Audio output connector
Power output connectors
Video output connector
Figure 2 SiteStand Connectors
RS-232
communication
connector
Printer and VCR
control connector
AC power input
connector
Fuse drawer
-type fuse.
®
Chapter 2: Using the SiteStand
11