Residual Risks; Device Elements - Würth DCN 3264 Traducción Del Manual De Instrucciones De Servicio Original

When changing workplace or if the device is
■
not being used or when it is being transported
or stored, as well as in the event of jams or
maintenance work, the following applies: Keep
your fingers away from the trigger and discon-
nect the compressed air supply.
Slippy handles can result in a loss of control:
■
Keep the handle dry, clean and free of grease
and oil.
When firing nails, allow for a recoil.
■
Therefore, during operation, do not hold your ■
head directly over the air nailer and start with a
low penetration depth.
Ensure you have a safe and well-balanced
■
posture, especially on platforms as well as on
high and/or inclined, uneven or slippy working
surfaces.
The air nailer must not be used from a ladder.
■
Air nailers must not be used to close boxes or
■
crates.
The air nailer must not be used to attach trans-
■
port locks to vehicles and trucks.
In the following situations, nails can
break into several parts after their inser-
tion causing severe injuries:
If too soft, thin or too hard materials are pene-
■
trated or if the penetration depth is set too high.
If nails impact other nails after penetration.
■
Maintain at least 5 cm distance from edges
■
and corners.
Do not use the air nailer if people are present
■
opposite to the nailer.
Always position the air nailer at an angle of
■
90° to the surface.

Device elements

General view (fig. A)
1 Rotating air outlet
2 Self-cleaning air filter*
3 Switchable trigger
(Single/contact activation)
4 Trigger lever
5 Magazine*
6 Nail length adjuster*
24
Safety instructions
Protection of persons:
Do not hold the handle too forcefully.
■
Take a break if your fingers/arms feel numb,
■
extremely hot or cold or you are suffering from
pins and needles. Consult a doctor if such
symptoms keep occurring.
Property damage:
Do not use the air nailer in the rain or in very ■
damp surroundings.
Do not expose the air nailer to high tempera-
■
tures, e.g. direct sunlight.
Only use the air nailer outdoors or in well ven-
■
tilated areas at temperatures between -10°C
and 40°C.
Do not use the air nailer with an empty maga-
■
zine.
Only store the air nailer in dry, frost-free rooms.
■
Stop work immediately in the following
situations:
If the hose is visible damaged.
■
If screws or other parts have come free or fallen
■
from the device.

Residual risks

In spite of observation of the applicable safety
regulations and the
Use of protective devices, certain risks
cannot be avoided. These include:
Damage to hearing.
■
Risk of injury due to projectile parts.
■
Risk of burns due to accessories becoming hot
■
during operation.
Risk of injury due to persistent use.
■
7 Drive depth adjustment
8 Magazine closure*
9 Set-down protection with tip claw*
10 Locking pin for magazine clamping lever**
11 Magazine clamping lever**
12 Workpiece contact**
13 Clamping bracket**
* DCN 3264 only
** DKN 3065 Combi only