Tabla de contenido
Swing Beam Hardware
1. Flip 4'' x 4'' Swing Beam over so that the opposite side of your drilled holes are facing upwards.
2. Place one (1) Wood Loc Washer on each Carriage Bolt with tangs facing downward.
3. With a hammer tap bolts through drill holes in Swing Beam until tangs sink fully into the wood as shown in
(Fig. 11).
4-1/2''
CARRIAGE
BOLTS
FOR SWING
HANGERS
4'' CARRIAGE
BOLTS
FOR A-FRAME
WOOD LOC
WASHER
21
Assembly Instructions
Fig. 11
Tabla de contenido
