Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8. Blade Assembly.
WARNING: To reduce the risk of serious bodily injury,
DO NOT use power tools to assemble the blades. If
overtightened, blades may crack and break.
Locate 15 blade attachment screws/washers in
hardware pack. Locate 15 blade attachment screws
and washers in hardware packs. Hold blade arm up to
blade and align holes. Insert 3 blade attachment
screws (along with washers) with fingers first and
then tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
Remove blade arm screws/lock washers from
underside of motor. Slide blade arm through one of
the openings on motor housing, aligning holes in
blade arm with holes located on the underside of the
motor housing--refer to drawing at right.
arm with blade arm screws/lock washers. Before
securing screws permanently, repeat this procedure
with the remaining blade arms. Securely tighten all
screws.
Note: Tighten blade arm screws twice a year.
9. Light Kit Assembly.
Place the light kit fitter on its base to
disassemble it. Remove finial, hex nut and
rubber washer. Carefully lift the glass shade
cage from the light kit fitter base. Now,
carefully remove the glass shade and set in
a safe place for later use.
["Light Kit Assembly" continued on next
page.]
Attach blade
glass
shade
page 7
blade arm screws/
opening
lock washers
finial
hex nut
rubber washer
light
kit fitter
blade attachment
screws/washers
blade
blade arm
glass
shade
cage
light
kit fitter
base
Capítulos
Tabla de contenido
