Stand Assembly & Adjustment; Height Adjustment - Vornado 533DC Guia Del Propietario

STAND ASSEMBLY & ADJUSTMENT
(MODEL 683DC)
No tools required.
STAND ASSEMBLY
1. Place the circulator head face down on
the ground on a soft surface.
2. The upper pole and lower pole are
pre-assembled with the Fastening Nut
(D) secured on the underside of the
base. Rotate Fastening Nut counter-
clockwise to remove and set aside.
3. Loosen the Adjustment Collar (F) by
gently rotating it counter-clockwise.
Extend the poles by 3-4 inches and
retighten collar.
4. Insert power cord (A) into the top of
Pole and pull through the bottom.
5. Push the circulator head into the pole.
Push until the Lock Release Button (B)
snaps through the Hole (C).
6. Assemble Legs onto the base of Pole
by pushing each Leg onto the grooves
(E). Replace Fastening Nut (D) by
rotating clockwise to secure all the
Legs in place.
6
English
NOTE: Poles must be
extended to fit on
circulator head.
A
Loosen
F
NOTE: Do not
overtighten
Adjustment
Collar as height
adjustment
could become
difficult.

HEIGHT ADJUSTMENT

(32 - 38 INCHES)
1. Support the Circulator Head (G) with one hand.
Use your other hand to loosen the Adjustment
Collar (F) by gently rotating it counter-clockwise.
B
2. Slowly raise or lower the Pole to the desired
height and secure into position by rotating the
Adjustment Collar clockwise until tight.
Note: Before adjusting
C
the height or rotating
the head, check that
the power cord is not
tangled and able to
E
move freely.
After adjusting height,
ensure that the
Adjustment Collar is
fully tightened and
engaged to ensure
Circulator Head does
not rotate and bind
power cord.
D
G
F