Features & Benefits; Pedestal Assembly & Adjustment - Vornado VFANJR Manual De Instrucciones

FEATURES & BENEFITS
Inlet Guide Cones direct air to the most efficient
TWIN AIR
parts of the propeller blades.
CONES
DEEP-PITCHED
Deep-pitched propeller blades "bite" off and
PROPELLER
circulate more air.
BLADES
Dual injector cones and powerful blades cause
VORTEX
TORNADO the air leaving to spiral - allowing it to travel
ACTION
farther than typical fans.
For fully flexible performance, Vornado gives you
MULTIPLE
as much or as little air as you desire. VFANJR
SPEEDS
features two speeds; VFAN, VFANSR, VFANSRP
three speeds.
FULL ACTION Direct the airflow with the touch of your fingers
PIVOT HEAD
with the easy-to-adjust head.
All moving parts are enclosed for safety
SAFE and QUIET
DESIGN and silence.
ADJUSTABLE Fully adjustable stand that adjusts from 107 cm to
HEIGHT
140 cm in height.
(Model VFANSRP only)
8
English
Circulate All Over the Room
A Vornado circulates all the air in the room so everyone is
comfortable. Air in motion feels cooler than air that is stagnant.
By providing whole room circulation, a Vornado allows you to
turn the thermostat up without sacrificing comfort.
PEDESTAL ASSEMBLY & ADJUSTMENT
MODEL VFANSRP (VFAN SR PEDESTAL) ONLY — HEX WRENCH REQUIRED (INCLUDED)
WARNING: The power cord is pre-threaded through upper and lower poles. To avoid damaging the power cord, take care when removing
product from box packaging.
Circulator
For quick assembly, follow these steps:
Head
1. Place carton on its side on carpeted or other soft surface
and gently slide circulator and all packaging components
out. Remove all packaging and set aside.
Yoke Cap
Upper Pole
Collet
2. Place circulator head face down on soft surface. Align
circulator head, upper pole and lower pole. Make
sure cord is not entangled and is able to move freely
Lower Pole within poles.
Top of Base
3. Slide lower pole onto upper pole. Using provided hex
wrench, use counterclockwise rotations to remove set
screw from collet. Slide collet onto lower pole until it
stops. Check to make sure holes in collet and pole align.
Replace set screw and tighten clockwise with hex wrench.
To avoid damage to product, be sure set screw is fully
aligned and engaged with hole in lower pole.
9
English