Before Initial Use; Stand Assembly; Height Adjustment - Vornado 530 Guia Del Propietario

Before Initial Use

Preparing the product for use
For best performance and safety, position product so airflow is not
†
obstructed.
† Before use, check appliance for visible damage. Do not operate
appliance if there is evidence of damage to device or if the device
has been dropped.
IMPORTANT INSTRUCTIONS
As a result of a chemical reaction, it is possible for product feet to
leave a visible residue on the furniture. The product should therefore
not be placed on furniture surfaces without suitable protection.
Installing Protective Feet
Use the feet to protect floors when using your air circulator on uncar-
peted surfaces such as hardwood, vinyl, or tile. The feet are simple to
install and will help maintain the whisper-quiet operation.
Cushion Ring Feet
(Model 783 only)
The cushion ring feet are packaged separately
in the box. To install, roll or clip all feet onto
the base and space evenly. For balanced sup-
port it is recommended to use 4 ring feet.
8
English

STAND ASSEMBLY

Cushion Pads
(Model 683)
(Model 733/735 only)
Use guide marks on base bottom for location. 1. Your circulator's power
1. Place 4 pads over the 4 edge bends.
2. Place 2 pads on each of the curved ends.
2. Push the Circulator Head
3. Remove the Fastening
4. Assemble Legs onto the
cord is already threaded
through the tubes and
base assembly. Be careful
to ensure the cord is not
interfering or binding.
into the Pole. Push until
the Lock Release Button (B)
snaps through the Hole (C).
A
Nut (D) secured on the
underside of the base.
Rotate Fastening Nut
counter-clockwise to
remove.
base of Pole by pushing
each Leg onto the grooves
(E). Replace Fastening Nut
(D) by rotating clockwise to
secure all the Legs in place.
Before Initial Use

HEIGHT ADJUSTMENT

(31 - 38 INCHES)
1. Support the Circulator Head
(A) with one hand. Use your
other hand to loosen the
B
Adjustment Collar (B) by gently
rotating it counter-clockwise.
A
2. Slowly raise or lower the
Pole to the desired height
C
and secure into position by
rotating the Adjustment Collar
clockwise until tight.
E
Note: Before adjusting the
height or rotating the head,
check that the power cord is
not tangled and able to move
freely.
B
After adjusting height, ensure
that the Adjustment Collar is
fully tightened and engaged to
ensure Circulator Head does
D not rotate and bind power
cord.
9
English