STACK-ON GCB-5300RTA Manual De Instrucciones página 2

HELPFUL HINTS:
When assembling the cabinet body, only hand tighten the bolts until all the parts are assembled. This will make it easy to
align all the holes.
A small Socket Wrench with a 7/16" (11mm) Socket is the best way to tighten the interior Nylon Locking Nuts. Hold the
head of the Carriage Bolt in the square holes of the cabinet while tightening the bolts. Do not over tighten these bolts.
For easier assembly, follow the exact sequence of assembly steps shown in the following pages.
ASSEMBLING THE CABINET:
1. Assemble the side panels to the Back Panel.
For easy assembly, stand the panels up as shown. Assemble each side with (6) Carriage Bolts, Lock Washers and Nylon
Locking Nuts. Hand tighten the bolts at this time. (See Figure 1)
For the entire assembly of the cabinet body, the heads of all the Carriage Bolts will be on the outside of the cabinet.
2. Keep the assembly standing up as shown. Locate the Bottom Panel (the one with 2 holes in the center of the panel)
and place it on the sides and back assembly. The front and back flanges of this panel must be on the outside of the
cabinet. (See Figure 2) The side flanges will be on the inside of the cabinet.
Assemble with (10) Carriage Bolts, Lock Washers and Nylon Locking Nuts. Hand tighten the bolts at this time.
Now turn the entire unit over to prepare for assembling the Shelves and Top Panel.
LOCK WASHER
NYLON LOCKING NUT
BACK PANEL
SIDE PANEL
CARRIAGE
BOLT
SIDE
PANEL
Figure 1
Mounting holes
Back
Flange
BOTTOM PANEL
Front flange
Figure 2
40155-1204
2
21