Use And Maintenance Instructions; Operation; Control Panel Symbols Fig. 9; Control Panel Symbols Fig. 10 - ASBER G-OEM-500 Instrucciones De Instalación, Uso Y Mantenimiento

EN

5. USE AND MAINTENANCE INSTRUCTIONS

5.1 Operation

The steps required to optimise the operation of your dishwasher are shown below, with all the available
options.
5.1.1

Control panel symbols Fig. 9

A. Cycle selector button
B. Machine on pilot light
C. Machine ready pilot light
D. Pilot + Push button wash cycle start
E. Machine OFF
5.1.2

Control panel symbols Fig. 10

J. Button (ON/OFF)
P. Salt need pilot light (Mod. SOFT)
Q. Machine ready pilot light
5.1.3

Control panel symbols Fig. 11

J. Button (ON/OFF)
K. Boiler water temperature display
L. Tank water temperature display
M P. Salt need pilot light (Mod. SOFT)
5.1.4

Switching on the machine

Before switching on the machine, check the following:
 The mains switch must be on.
 The water stop cock must be open.
 There must be water in the mains network.
 The corresponding filters must be in place.
 The overflow should be mounted in place.
To switch on the machine in the G models (Fig.9), turn the selector switch from 0 to WASH CYCLE.
In the GM (Fig.10) and GT (Fig.11) models, just press the ON/OFF button once for 1.5 seconds.
5.1.5

Filling and heating

When the machine is switched on, it will start to fill. First the rinse boiler is filled and then the wash tub.
The filling process may last a few minutes. Once the wash tub is full, the boiler starts to heat up and
when it is hot, the tub is heated. Although it is possible to start the wash process, this is not
recommended as the water inside the machine is not yet at the ideal temperature.
In G (Fig. 9) and GM (Fig.10) models, when machine reaches optimum washing temperature, green
led light will light up, while in GT (Fig.11), working temperature can be visualized in the display (K &
L).
The temperature in the boiler should be between 82-90 ºC and in the tank between 57-62 ºC (see
figure).
BEFORE STARTING THE APPLIANCE, PLEASE READ THE INSTRUCTIONS
CONTAINED IN THIS MANUAL CAREFULLY.
THE APPLIANCE IS EXCLUSIVELY FOR PROFESSIONAL USE, AND SHOULD
ONLY BE USED BY QUALIFIED PERSONNEL.
F. Wash cycle 1 (120s)
G. Wash cycle 2 (90s)
H. Wash cycle 3 (180s)
I. Drainage cycle (Only Mod. B)
M. Wash Cycle 1 (90 s) / Drainage (Mod. B)
N. Wash Cycle 2 (120 s) / Regeneration (Mod.SOFT)
O. Wash Cycle 3
M. Wash Cycle 1 (90 s) / Drainage (Mod. B)
N. Wash Cycle 2 (120 s) / Regeneration (Mod.SOFT)
O. Wash Cycle 3 (180 s)
49