Canopy Assembly; Blade Assembly; Light Kit Assembly. Pgs - Craftmade Acadian Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then
tighten both screws securely.

8. Blade Assembly.

WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and break.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 9 blade attachment screws and
washers in hardware pack. Slide blade
through one of the narrow, rectangular
openings on motor housing, aligning holes
in blade with holes in blade arm (located on
the underside of the motor housing)--refer
to drawing at right. Insert 3 blade attachment
screws (along with washers) with fingers first
and then tighten screws securely with a
Phillips screwdriver. Repeat procedure for
each remaining blade.
NOTE: Tighten blade arm screws twice a year.
9. Light Kit Assembly.
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted holes
in fitter plate with loosened screws in motor
plate, allowing molex connections from motor
housing to come through hole in middle of
fitter plate--remove and discard plastic that
holds these 2 wires together. Twist fitter plate to
lock. Re-insert screw that was just removed
and securely tighten all 3 screws with a Phillips
screwdriver.
canopy
screw
blade
arm
motor
housing
motor plate
fitter plate
page 7
hanging
bracket
screw
motor
housing
blade
blade attachment
screws and washers
molex connections