Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Troubleshooting
(cont.)
Any mode is selected but nothing happens.
• Lid isn't locked. Make sure to push Lid Lock Lever to lock Lid in place.
• Blue lights on control panel will flash when Lid is properly latched.
Part of bag was not sealed.
• Ensure that bag is aligned to left side of Vacuum Chamber.
Pump runs for an excessive length of time.
• WET VAC & SEAL requires a longer cycle than DRY VAC & SEAL. This is normal. If pump continues to run after all air appears to be removed from bag or if it runs
longer than one minute, press SEAL Button to end cycle. This may occur at very high altitudes.
• Check for wrinkles in the bag near the foam seal. If found, smooth out wrinkles and try again.
• Check the bag for holes. Even a pin-sized hole will prevent proper vacuuming.
• When making bags from rolls, check the first seal to make sure it's complete before filling the bag and vacuum sealing.
PROGRESS Bar lights flashing red.
• Flashing red lights on PROGRESS Bar as soon as Lid is latched. Call Customer Service.
• Function button pressed and Vacuum Sealer is not working. Let Vacuum Sealer cool 15 minutes and start again.
Liquid is pulled into Vacuum Chamber.
• A small amount of liquid may collect in the Vacuum Chamber. This is normal. Wipe out Vacuum Chamber between each cycle as needed.
Liquid is present in the top edge of bag, above the seal.
• A small amount of liquid may be pulled into the edge of the bag. This is normal. Wipe moisture from edge of bag before storing.
9
Tabla de contenido
