Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Making Bags From Rolls
1. Open Roll Caddy Door and rest on
counter.
2. Lift Roll Cutter Bar and pull enough
heat-seal roll out to fit the item to
be sealed plus another 3 inches
(7.62 cm). Lower Roll Cutter Bar
and slide Roll Cutter across to cut.
3. Plug into outlet.
4. Place one open end of bag over
Heat-Seal Strip. For best sealing,
place curl side down so end of
bag points down into chamber.
Be sure there are no folds or
wrinkles.
DRY VAC
SEAL
& SEAL
5. Close Lid and push Lid Lock Lever
to lock Lid in place.
6. Press SEAL Button.
w CAUTION
Burn Hazard. Seal bar and
Date Code Heater are hot. Avoid touching.
WET VAC
& SEAL
7. The PROGRESS Bar will
illuminate green during operation,
progressing from left to right.
When finished, unit will beep.
8. Pull Lid Lock Lever up to release
Lid and remove bag.
9. Unplug when finished making
bags.
NOTE: Red lights on the PROGRESS
Bar indicate an error. See
Troubleshooting section.
5
Tabla de contenido
